The new washing machine has been delivered, unpacked, installed at its workplace and connected to the water supply. So you want to run it as soon as possible and see it in work? Experts recommend not to rush, since its performance and durability depend on the first inclusion and starting wash. The rush and wrong actions of the new owner can not only harm, but even disable an expensive unit. The first start of the washing machine should be carried out in accordance with the manufacturer's recommendations. Therefore, it is important to carefully read the attached instructions.
Preliminary preparation of the washing machine
Before the first launch, a complete installation of the equipment should be carried out: water and sewage hoses are connected, the device is set to level, the transportation bolts that hold the drum during loading and transportation are removed.
Before the first start-up, you should conduct a readiness check. It will not take much time, but will protect the owner from surprises that may arise if something in a hurry was missed.
Readiness Check
Before turning on and starting the washing machine for the first time, it is recommended:
- Carefully read the operating instructions. In this case, special attention should be paid to the section on managing washing modes. Incorrect user control may affect the operation of the electronic unit of the device.
- Check the connection of the machine’s hoses: rubber for water supply (bulk) and corrugated for draining into the sewer (drain). It is better to fix the corrugated hose, as with the active draining of water from the washing machine, it can fall out and cause a flood.
- Check the back of the machine for shipping bolts. They fasten the internal parts of the machine and the drum for safety during tilting and transportation. If the bolts are in place, they must be removed and the holes closed with rubber covers, which are usually included with the machine. In most cases, the manufacturer provides 4 shipping bolts.
- Open the water shutoff valve on the inlet hose.
- Check if the remnants of the adhesive tape that secures the parts are removed from the front, rear and side walls of the machine.
- Open and inspect the drum of the washing machine for debris or any parts in it.
These are mandatory steps that must be performed before the first start of the washing machine.
First wash
Manufacturers of washing machines and experts recommend that the first wash be done in vain - without laying the laundry, and be near the machine all the time.
Instructions for starting a startup launch:
- Turn on the power to the device.
- Close the loading door until it clicks into place.
- In the compartment for the powder and the air conditioner, add a special tool for the washing machine for the first start-up or regular powder.
- On the control panel, select the "Cotton 60 °" mode, start it and wait for the wash to finish.
- Listen to the noise of the typewriter during operation, its measured buzz and if there are any grinding or knocking sounds.
- When touching a working device, vibration and shaking should not be felt (in the case of a correct level setting, even on the spin, the machine should not move).
- Inspect the machine after completing the first wash. Sewer and water hoses should be checked for smudges and water leaks under and around the machine.
What to pay special attention to?
The first launch of washing machines LG, Bosch, Candy, Indesit, Hotpoint Ariston, Samsung, Haier, Vestel, Beko and devices from other manufacturers is practically the same.
In all cases of abnormal operation and washing, call a specialist or look for the cause of the malfunction yourself.
If at the first start of the washing machine the user detects a knock, rattle, or other strange sounds without delay, it is worth calling a specialist from a repair shop or service center. You cannot wash before troubleshooting, even if the problem does not seem serious.
The recommendations for the first wash without laundry are based on the fact that most of the surfaces of the drum and drains are most often contaminated with technical fluids and oils, the use of which is necessary during assembly at the factory. In addition, these same parts can retain odors for a long time. The main thing, with such an idle wash, is to check whether the parts and components of the new machine are working normally, whether the water supply and drainage system is tight.
Laundry Detergents
Specialized household appliance stores offer a low-cost tool for starting up the washing machine for the first time. It contains active surface substances that destroy all technical odors, dirt and impurities. After using this product in the washing drum for a long time there is a pleasant smell. This is added during the first wash to the powder container.
Tips for proper washing
For the washing machine to last a long time, you need to listen to simple tips:
- do not overload the machine with excess laundry;
- Separate white linen from color and do not wash them together;
- Check pockets of loaded items, especially for metal objects;
- when softening, use water softeners, conditioners when washing;
- clean the drain hose filter from small debris;
- wipe the panel of the machine, the drum door with special substances that do not contain chlorine and abrasives.
Recommendations for the first launch of the washing machine Bosch, Candy, LG, Indesit, Hotpoint Ariston, Samsung, Haier, Vestel, Beko and other companies, as well as their further operation, are practically no different. Implementation of these simple recommendations will help maintain the longevity of household appliances without repairs.