Buying new watches, people often face the problem of a large bracelet or strap. To make it smaller, just make an extra hole in the right place. But how to shorten the watch bracelet? The easiest way is to go to the workshop, where the specialist in a few minutes will adjust the length to the required size. But you can do it yourself at home.
There are cases when the bracelet is purchased separately from the watch. To adjust the length in this situation, it is necessary, first of all, to install it on the watch. Without fitting it is impossible to determine whether it is worth removing the links at all. Within the norm, a slight sagging is allowed, and the bracelet should not be customized.
Ways to adjust the length of the bracelet
Most bracelets have two types of length adjustment. First, you can shorten the clock in the simplest way and change the length of the bracelet by adjusting the lock. To do this, remove the ear of the lock with a simple press and rearrange it into the hole closest to the latch. If the length has changed slightly, and the watch is still hanging out, only removing the extra links will help.
Disassemble the watch bracelet
To perform this rather simple task, it is necessary to prepare a workplace and some tools: an awl, a nut, a hammer, and pliers. The links in the bracelet can be fastened to each other with the help of pins, screws or studs. The pins and studs when disassembling the bracelet are knocked out or squeezed out, and the screws are unscrewed. The awl in diameter should not be thicker than the hole in which the fastener is located. The diameter of the tool should not exceed the hole in which the fastener "sits". Instead of an awl, a gypsy needle, a pair of compasses or a drill suitable in diameter will also come in handy. How to shorten the watch bracelet in this case? To remove the mount with a needle or drill, you have to strike with a small hammer.
Before proceeding to disassemble the bracelet, it is necessary to count the exact number of links to be removed from the lock.
How to shorten a watch bracelet and take into account the number of links
When removing links from a bracelet, one should remember the need to maintain symmetry, otherwise the lock of the bracelet will shift to one side, which will cause inconvenience when wearing. The number of elements suitable for removal depends on their size, and is usually limited to five or six pieces on each side. Reducing the product is better to start from the third position, since usually the first two are larger. To shorten the bracelet of the watch, it must be put on its side, placing a nut between the links, aligning the pin or stud, which must be removed with the hole in the nut.
Using an awl, we squeeze the connecting pin or pin. An arrow indicating the direction of movement is usually applied to the back of the bracelet. The pliers will help to fully pull out the mount. After the pins or pins are pulled out, it will become clear how to shorten the watch bracelet. You just need to connect the remaining parts, making sure that the fasteners sit tight. Similarly, you can fit almost any bracelet in size. This is not a complicated matter, but it requires accuracy so as not to damage the watch itself.